MDRWM - Roller bed belt conveyor

MDRWM – FLAT WIRE MESH, ROLLER BED WITH 1.90″ DIAMETER ROLLERS

BELT WIDTH: 12″, 18″, 24″, 30″, 36″

LENGTH: 60″ to 720″

BEGINNING HEIGHT ELEVATION:  9″ to 126″

ENDING HEIGHT ELEVATION: 19″ to 126″

ROLLERS: 1.9″ diameter, 16ga wall tubes with 7/16″ hex cold rolled steel axle spring retained. Precision greased packed bearings.

ROLLER CENTERS: 6″

BELT: Standard galvanized with clinched edge. Options include galvanized or stainless material with clinched or welded edge.

DRIVE LOCATION: End drive, bottom right hand. Optional drive locations include end drive, bottom left hand; side drive right or left hand.

MOTOR: 1/2 HP to 1-1/2 HP, totally enclosed fan cooled motor. Optional inverter duty or power off brake motor also available. Standard voltage is 230/460 3Ph / 60Hz. Optional voltages include 115V/ 1PH/ 60Hz, 208V/ 1Ph/ 60Hz, 230V/ 1Ph/ 60Hz, 575V/ 3Ph/ 60Hz, or 90V DC.

SPEED: 15 to 60 FPM (feet per minute). Reverse capability optional.

CONVEYOR COLOR: Powder coated blue (RAL 5017). All guarding is yellow (RAL 1023) and moving parts are bright red orange( RAL 2008). Click HERE to see other standard color options. Custom colors also available.

Conveyor Control Options:

  • No controls (provided by others)
  • Variable Speed Controller in NEMA 4X enclosure
  • Combination motor starter with disconnect, fixed speed
  • Combination motor starter with disconnect, variable speed
  • PLC (programmable logic controller) with HMI (human machine interface)

Optional

  • Photo eye sensor(s)
  • Emergency Stop button(s)
Load Capacity @ 60 FPM (LBS)
HP Width
12″ 18″ 24″ 30″ 36″
 1/2 655 585 520 450 380
 3/4 1065 995 925 860 790
1 1470 1405 1335 1265 1200
1 1/2 2290 2220 2150 2085 2015
Load Capacity @ 30 FPM (LBS)
HP Width
12″ 18″ 24″ 30″ 36″
 1/2 1480 1410 1345 1275 1205
 3/4 2300 2230 2160 2090 2025
1 3115 3045 2980 2910 2840
1 1/2 4750 4680 4615 4545 4475

MAXIMUM LOAD PER LINEAR FOOT OF CONVEYOR

IS 75 POUNDS – NOT TO EXCEED CAPACITY ABOVE

Supports: 

  • No floor supports
  • Adjustable height supports (model SPH or SPL)
  • Adjustable height supports on 5″ casters (model SPHC5) with leg-ties
  • 4″ formed channel jack bolt supports, adjustable 1 to 2″ (model SPJ4 or SPJ4A)
  • Ceiling support brackets

Floor supports can be provided on 5′ or 10′ centers. It is recommended that conveyors wider than 32″ have supports on 5′ centers. It is also recommended that conveyors with height elevations above 35″ use knee braces (model KB17)

Guardrail:

  • 2″ to 12″ high
  • Bolts on one or both sides of conveyor frame
  • Models GFS12 or GFS8