Model BDLR25 is a heavy duty, minimum pressure accumulation conveyor which provides an effective means of accumulating heavier products with minimal back pressure. This conveyor can be effective for loads that require higher capacity rollers on closer centers.

BDLR25 – HEAVY DUTY BELT DRIVEN ROLLER WITH 2.50″ DIAMETER ROLLERS

BETWEEN FRAMES: 15″ – 57″

LENGTH: 60″ – 960″

BEGINNING ELEVATION: 12″ – 108″

ENDING ELEVATION: 12″ – 108″

SPEED: 10 – 120 FPM

ROLLER CENTERS: 3″, 4″, 6″

ZONE LENGTH: 36″, 48″, 60″, 72″, 84″

ROLLERS: BDLR25 Roller – 2.50” diameter, 11ga wall tube. BDLR26 Roller – 2.625” diameter, 7ga wall tube. All rollers with 11/16” hex cold rolled steel axles, spring retained. Standard bearings are precision, grease packed bearings.

BELT: Standard 12” wide Trackmate PVC120 with clipper lacing supported on 1.9” diameter 16 gauge rollers with precision bearings. Optional non-woven NBR Ultimate.

DRIVE: Standard drive is an end drive, right hand side. Optional drives include end drive, left hand side; and center drive, right hand side.

MOTOR: 3/4 HP through 1-1/2 HP, Energy efficient and inverter duty motors also available. Voltages include 120/1/60, 230/3/60, 460/3/60, 575/3/60 & DC Voltage.

MINIMUM PRESSURE ACCUMULATION: Drive force is set by making adjustments to the pressure roller adjusting rods, typically located on 60″ centers.

ROLLER SURFACE: Standard roller surface is carbon steel. Optional surface for 2.5” rollers includes galvanized roller tube.

SUPPORT CENTERS: Standard supports are floor supports on 5’ centers. Optionalon 10’ centers.

FRAME FINISH: Standard finish is OSHA safety blue powder. Optional colors include green, beige, gray, orange, black and yellow.